To properly test trigger reset during a function test, which procedure is correct?

To properly test trigger reset during a function test, which procedure is correct?

• A. Hold the trigger to the rear throughout the entire cycling process
• B. Release the trigger and manually rack the slide/bolt
• C. Continue firing without any further actions
• D. Let the trigger reset on its own without any manipulation during cycling

Answer: (A)

Trigger reset is about the trigger returning to its ready position after a shot so you can safely fire again. The correct procedure for testing this during a function test is to keep the finger on the trigger and hold it to the rear while the action cycles. By keeping the trigger depressed throughout the cycling, you isolate the reset behavior from any forward motion of the trigger during cycling and you can reliably observe that, as the slide finishes its cycle, the trigger reaches its reset point and is ready to be released and reapplied for the next shot. After the cycle is complete, you would then release and reapply pressure to confirm you can fire again, proving the reset point works correctly. Other approaches either don’t test the reset under cycling conditions or risk overlooking a faulty reset, such as releasing the trigger during cycling, manually racking the slide, or letting the trigger reset without holding it during the test.

Trigger reset is about the trigger returning to its ready position after a shot so you can safely fire again. The correct procedure for testing this during a function test is to keep the finger on the trigger and hold it to the rear while the action cycles. By keeping the trigger depressed throughout the cycling, you isolate the reset behavior from any forward motion of the trigger during cycling and you can reliably observe that, as the slide finishes its cycle, the trigger reaches its reset point and is ready to be released and reapplied for the next shot. After the cycle is complete, you would then release and reapply pressure to confirm you can fire again, proving the reset point works correctly. Other approaches either don’t test the reset under cycling conditions or risk overlooking a faulty reset, such as releasing the trigger during cycling, manually racking the slide, or letting the trigger reset without holding it during the test.